Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements
Webcast-Catalyst9k
New Member

Cat4000 IOS Sup III ME Interface

How do I assign an IP address to the Management Ethernet of a Cat4014 with native IOS ? (SW: (cat4000-IS-M), Version 12.1(11b)EW1)

Thanks

Mat

1 REPLY
Cisco Employee

Re: Cat4000 IOS Sup III ME Interface

The me1 ethernet port is actually only addressible from rommon, and used only for image recovery procedures. The me1 port is not even visable interface in the new IOS when the switch is up and functional. If you are looking for a management IP address, configure a VLAN interface and assign it an IP address

http://www.cisco.com/warp/public/473/149.html

83
Views
5
Helpful
1
Replies
CreatePlease to create content