Trying to implement an EMC NAS on our system. Have a Cat 4006 as my core switch, which has never been configured for vlans as they have not been needed in our environment. Switch was basically plug/play aside from assining the management IP and passwords.
Installer for the EMC equipment is asking to have 8 ports placed into two etherchannels for the connections of the data movers.
I've got documentation, but cannot seem to get this to work. I'd like to set ports 2/18 - 2/21 to the first ether channel and 2/22 - 2/25 into the second. I've tried setting the port channel, but when I show port channel it returns "no ports channelling"
Also, as for creating a VLAN (is this necessary to do what we are trying to do) requires setting the VTP domain (which has never been set and I not familiar with what this should be set to).
I'm a bit green and out of my league here, but the installer is insisting on this setup but is also not qualified to do it.
Hi everyone, I would like to thank you in advance for any help you can provide a newcomer like myself!
Im studying the 100-105 book by Odom and am currently on the topic of Port security. I purchased a used 2960 and I'm trying to follow a...
While deploying a number of 18xx/2802/3802 model access points (APs), which run AP-COS as their operating platform. It can be observed on some occasions that while many of their access points were able to join the fabric WLC withou...
I am going to design and build an LAN network under a tunnel underground with long distance between the switches.
I will have 2 Catalyst switches and 8 Industrial IE3000, and they will be connected with fiber.
For now I am planning on use Layer-2 s...