Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

Cat4006-Sup3...Whats The Difference between...

The following commands?

Cat4006 Sup3# ip forward-protocol udp netbios (ports 137,138,139)

and

Cat4006Sup3# ip helper address [ip-address]

I was under the impression that the 1st command, since it is a Global config command, would allow NetBios name resolution to pass thru the L3 engine, thus allowing Windows Workgroups to see each other via Network Neighborhood.

That didnt happen until I issues the 2nd command, which I understood to be for allowing DHCP broadcasts. ????

TIA

1 REPLY
New Member

Re: Cat4006-Sup3...Whats The Difference between...

80
Views
0
Helpful
1
Replies