02-23-2006 06:16 AM - edited 03-03-2019 01:58 AM
I have a Cat 4510R with SUP V-10GE running
under IOS cat4000-i9k91s-mz.122-25.EWA5.bin
Configuring and connecting one of the SFP
GigE Port as a trunk does not work. Here is
my configuration
interface GigabitEthernet1/6
switchport trunk encapsulation dot1q
switchport trunk allowed vlan 1,128,192,400
switchport mode trunk
when configuring on of the GigE ports I get the warning:
c4k6-ikp-1(config)#interface GigabitEthernet1/4
% WARNING: Interface GigabitEthernet1/4 is usable/operational only in gigabit
% uplink configuration.
What does it mean ?
Thanks in advance greetings Manfred
Solved! Go to Solution.
02-23-2006 06:29 AM
Hi,
You can use either the sfps or the 10 gigs on this platform. You probably have the default config on it, "hw-module uplink select tengigabitethernet"
which means, "Use the 10 gig uplinks". Your sfps will always be inactive in this configuration. If you want to use the SFP ports instead, configure
"hw-module uplink select gigabitethernet"
regards,
Bobby
Hope that helps, please rate helpful posts
02-23-2006 06:29 AM
Hi,
You can use either the sfps or the 10 gigs on this platform. You probably have the default config on it, "hw-module uplink select tengigabitethernet"
which means, "Use the 10 gig uplinks". Your sfps will always be inactive in this configuration. If you want to use the SFP ports instead, configure
"hw-module uplink select gigabitethernet"
regards,
Bobby
Hope that helps, please rate helpful posts
02-24-2006 01:05 AM
Hi,
thanks very much; this works !
Greetings
Manfred
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide