Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
New Member

Cat4k Sup-3 and DLSw

I have a 2600 router connected to a T1 circuit. The other end of the circuit will be sending data using DLSw. Is this supported in the Cat4k box and what, if any, special config will I need to do on the Cat4k?

Thanks.

1 REPLY
Bronze

Re: Cat4k Sup-3 and DLSw

No special configuration is required on the Cat4K to pass DLSW traffic but be aware that DLSW is not supported over 802.1Q trunks, only ISL.

98
Views
0
Helpful
1
Replies
CreatePlease to create content