The me1 port on the SupIII is only active in ROMMON and should only be used for disaster recovery. Since SupIII is IOS, there is no sc0 interface. Instead, you assign a management IP address to a port or a VLAN interface. Creating a VLAN 1 interface and assigning an IP address will allow all ports in VLAN 1 to telnet to the switch.
The me1 ethernet port is actually only addressible from rommon, and used only for image recovery porcedures. The me1 port is not even visable interface in the new IOS. If you are looking for a management, configure a VLAN interface
Hi everyone, I would like to thank you in advance for any help you can provide a newcomer like myself!
Im studying the 100-105 book by Odom and am currently on the topic of Port security. I purchased a used 2960 and I'm trying to follow a...
While deploying a number of 18xx/2802/3802 model access points (APs), which run AP-COS as their operating platform. It can be observed on some occasions that while many of their access points were able to join the fabric WLC withou...
I am going to design and build an LAN network under a tunnel underground with long distance between the switches.
I will have 2 Catalyst switches and 8 Industrial IE3000, and they will be connected with fiber.
For now I am planning on use Layer-2 s...