08-28-2002 12:36 PM - edited 03-02-2019 12:58 AM
I have a cat 5000 with a sup 1 card running code 3.2, recently I noticed the supervisor engine had a fault status when I did a show module. What I would like to know is what is a fault status and what kind of traps should I receive.
Thanks in advance
Dennis
08-28-2002 12:52 PM
Do a sh system and check to see if all power supplies are good and powered up. Also check for fan status
08-28-2002 04:53 PM
Also the following page on Hardware Troubleshooting for Catalyst 5500/5000/2926G/2926 Series Switches should help
http://www.cisco.com/warp/public/473/120.html#System-Component-Problems
08-29-2002 07:15 AM
Thanks for your response, what I really wanted to know what are some of the possibilities that can cause the sup engine to show a status of fault, and since I have snmp configured to send traps for module and chassis what traps would be sent.
Thanks
Dennis
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: