Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
Community Member

Cat6000 Bootproblem

Hello,

a Catalyst 6509 switch does not boot properly. Console output shows

that a cat6000-sup.5-5-1.bin image is decompressed, then following

tests are passing and the last output-line is

Boot image: bootflash:cat6000-sup.5-5-1.bin

Normally the next line would be:

"Running System Diagnostics from this Supervisor (Module 1)"

but instead the switch hangs and the LEDs on the SUP1A

are Status: green; System: red; Active: amber; PowerMgmt: amber.

So my question: Is there a recovery procedure or which

part need to be replaced?

2 REPLIES
Cisco Employee

Re: Cat6000 Bootproblem

If you have a PCMCIA card in slot0 and have a valid image in it, try booting from it. Was this switch up and running with 5.5(1) before? If not make sure your Sup has minimum bootrom version of 5.2(1)

http://cio.cisco.com/univercd/cc/td/doc/product/lan/cat6000/relnotes/78_6218.htm#xtocid0

Community Member

Re: Cat6000 Bootproblem

I hop this link help you with your problem http://www.cisco.com/warp/public/473/119.html

regards

165
Views
0
Helpful
2
Replies
CreatePlease to create content