Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements
Webcast-Catalyst9k
New Member

Cat6500 conversion from hybrid to native

Is there a tool that will covert your existing supervisor configuration to a native IOS configuration?

2 ACCEPTED SOLUTIONS

Accepted Solutions
VIP Purple

Re: Cat6500 conversion from hybrid to native

Hello Jeff,

are you looking for this ?

Catalyst OS to Cisco IOS Configuration Converter

http://www.cisco.com/cgi-bin/Support/CatCfgConversion/catcfg_xlat.pl

Regards,

GP

Re: Cat6500 conversion from hybrid to native

Please be aware that not all configs will convert properly with this tool You might want to understand equivalent commands under each OS before you do the migration.

Check this link.

http://www.cisco.com/en/US/products/hw/switches/ps700/products_tech_note09186a008010e9d5.shtml

HTH

PS: please remember to rate helpful replies!

4 REPLIES
VIP Purple

Re: Cat6500 conversion from hybrid to native

Hello Jeff,

are you looking for this ?

Catalyst OS to Cisco IOS Configuration Converter

http://www.cisco.com/cgi-bin/Support/CatCfgConversion/catcfg_xlat.pl

Regards,

GP

New Member

Re: Cat6500 conversion from hybrid to native

This tool does not seem to be working at least over the last 5 days.

I have tried to upload and convert 8.3 catos config, and also tried cutting and pasting in the conversion box.

Browser status says: Opening page http://...catcfg_xlat.pl..

But conversion never happens, browser just times out.

Anyone else having problems?

New Member

Re: Cat6500 conversion from hybrid to native

Yes, I had the same problem. I finally wrote a perl script to do the port-level configuration because I had a ton of ports. Adjust as you see fit:

open (PORTS,"sw2.txt");

open (NEWSW1,">sw2-new.txt");

@ports = ;

foreach (@ports) {

($port,$desc,$conn,$vlan) = /(\d+\/\d+)\s+(.*)\s+(connected|notconnect)\s+(\d+)\s+/;

if ($conn) {

print NEWSW1

"interface g$port\n desc $desc\n switchport host\n switchport access vlan $vlan\n no shutdown\n";

}

}

Re: Cat6500 conversion from hybrid to native

Please be aware that not all configs will convert properly with this tool You might want to understand equivalent commands under each OS before you do the migration.

Check this link.

http://www.cisco.com/en/US/products/hw/switches/ps700/products_tech_note09186a008010e9d5.shtml

HTH

PS: please remember to rate helpful replies!

141
Views
5
Helpful
4
Replies
CreatePlease to create content