Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
New Member

Cat6500 IOS: how to power-up a linecard

Hi,

I am managing a couple of Cat 6506 IOS.

I can reset or shutdown a linecard (e.g. a NAM) using the "hw-module" command; does exist any command to power up a shutted down line card?

Best regards.

Paolo Calcaterra

1 ACCEPTED SOLUTION

Accepted Solutions
Purple

Re: Cat6500 IOS: how to power-up a linecard

If you enter the 'hw-module shutdown' command to shut down the module, you will have to enter the 'no power enable module' command and the 'power enable module' command to restart (power down and then power up) the module.

Hope that helps - pls rate posts that help.

Regards,

Paresh

3 REPLIES
Purple

Re: Cat6500 IOS: how to power-up a linecard

If you enter the 'hw-module shutdown' command to shut down the module, you will have to enter the 'no power enable module' command and the 'power enable module' command to restart (power down and then power up) the module.

Hope that helps - pls rate posts that help.

Regards,

Paresh

Silver

Re: Cat6500 IOS: how to power-up a linecard

You can power down a module using the

no power enable module (slot) command

Power the module back up with the

power enable module (slot) command

Hope this helps answer your question.

Steve

Cisco Employee

Use of the CLI to Power

Use of the CLI to Power Modules Up or Down

You can issue one of these commands in order to power down a properly working module from the command-line interface (CLI):

The module is marked as power-down in the Status field of the show module command output. In order to verify if adequate power is available in the system in order to turn the power on for a module that was previously powered down, issue one of these commands:

If there is not enough power available, the module status changes from power-down to power-deny.

http://www.cisco.com/c/en/us/support/docs/switches/catalyst-6500-series-switches/22389-142.html

2612
Views
15
Helpful
3
Replies
CriarFaça o para criar o conteúdo