Buy or Renew
Buy or Renew
Cisco + Splunk: It’s a new day for your data. Learn more.
 
cancel
Turn on suggestions
Auto-suggest helps you quickly narrow down your search results by suggesting possible matches as you type.
Showing results for 
Search instead for 
Did you mean: 
cancel
Start a conversation
231
Views
0
Helpful
1
Replies

Cat6500 Native and VLANs

pgionas
Level 1
Level 1

‎06-09-2003 08:35 AM - edited ‎03-02-2019 07:59 AM

Hi

I am trying to configure a Cat6500 with 48 x Gig ports all using WS-6500 modules with on board DFCs (hence native IOS). I want to configure 10 x VLANS and 10 corresponding router interfaces, however, each VLAN will correspond to a single L2 Etherchannel trunk. Effectively i will be routing between EtherChannels....I dont want to use L3 load balancing since it doesnt match my topology. Does anyone have any sample config scripts

tia

Pete

Labels:
0 Helpful
1 Reply 1

owillins
Level 6
Level 6

‎06-13-2003 08:09 AM

Hi Pete,

I would recommend that you try the support page for Cat 6500. There is a section called Etherchannel. You might find the Sample config that you are looking for there.

http://www.cisco.com/pcgi-bin/Support/browse/psp_view.pl?p=Hardware:Cat6000&s=Software_Configuration

0 Helpful
Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community:

Customers Also Viewed These Support Documents