Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

Cat6500 Native and VLANs

Hi

I am trying to configure a Cat6500 with 48 x Gig ports all using WS-6500 modules with on board DFCs (hence native IOS). I want to configure 10 x VLANS and 10 corresponding router interfaces, however, each VLAN will correspond to a single L2 Etherchannel trunk. Effectively i will be routing between EtherChannels....I dont want to use L3 load balancing since it doesnt match my topology. Does anyone have any sample config scripts

tia

Pete

1 REPLY
Silver

Re: Cat6500 Native and VLANs

Hi Pete,

I would recommend that you try the support page for Cat 6500. There is a section called Etherchannel. You might find the Sample config that you are looking for there.

http://www.cisco.com/pcgi-bin/Support/browse/psp_view.pl?p=Hardware:Cat6000&s=Software_Configuration

92
Views
0
Helpful
1
Replies