Cisco Support Community
Showing results for 
Search instead for 
Did you mean: 

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Cat6500 Netflow detail missing (or is it?)

The documentation is somewhat vague about using Netflow on the Cat6k platform. I have configured it appropriately as follows:

mls flow ip full

mls nde interface

mls nde sender version 7

interface g1/1


ip route-cache flow

Now, I can *see* the flow info with "show mls netflow ip":

DstIP SrcIP Prot:SrcPort:DstPort Src i/f:AdjPtr


Pkts Bytes Age LastSeen Attributes

--------------------------------------------------- tcp :22211 :www 0 : 0

6 387 289 16:16:44 L3 - Dynamic

However, when I execute a "show ip cache flow," I don't see any of these flows.

I'd like to gain the stats from "show ip cache flow" at the CLI, but can't seem to figure out how. Please help!

New Member

Re: Cat6500 Netflow detail missing (or is it?)

I could not figure out what exactly is the problem but I found this document to be very useful on the NDE on cat6k.

New Member

Re: Cat6500 Netflow detail missing (or is it?)

Yes, that's the same doc I was working from. It doesn't give any indication as to what you should expect to see with show commands, though. For example, "show ip cache flow" on a normal router gives the info I need. This doesn't seem to work on a 6500. I don't know if it's working or not.

CreatePlease to create content