Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

CAT6509 and WS-X6548-GE-TX

Hi there,

I am new here but I wondered if any could tell me whether a Catalyst 6500 switch with a WS-X6K-SUP2-2GE engine and WS-F6K-MSFC2 switch feature card will support a WS-X6548-GE-TX 10/100/1000 ethernet module? The switch is installed with CATOS and MSFC2 is IOS.

Any help would be greatly appreciated.

Thanks in advance!

Cheers

2 REPLIES
Silver

Re: CAT6509 and WS-X6548-GE-TX

Yes it will provided you have the right CatOS version on the switch. One thing to note is that this is a fabric enabled card which basically means the performance is much higher when compared to a classic card; however, this increase in performance is only realized when a switch fabric module is installed in the switch.

Re: CAT6509 and WS-X6548-GE-TX

Hi Friend,

This card is very well supported with the hardware you are having but make sure you have minimum CATOS release 7.6(1) on supervisor however Cisco recommended CATOS release is 7.6(9) for this card.

Have a look at this link

http://www.cisco.com/univercd/cc/td/doc/product/lan/cat6000/relnotes/ol_4498.htm

HTH, if yes please rate the post.

Ankur

145
Views
5
Helpful
2
Replies
CreatePlease login to create content