12-16-2002 04:45 AM - edited 03-02-2019 03:37 AM
While doing an upgrade to sup1A MSFC I founf that I could not session to 15.
I´m pretty sure that I mest up with the boot variables.
How can I access the MSFC (rommon) and fix this?
Thanks
12-16-2002 05:02 AM
Never mind I found a document to do this. Can I configure HSRP between two Cisco 6000, where one has SUP1A PFC/MSFC2 and the other SUP1A PFC/MSFC?
12-16-2002 05:50 AM
The following document should help
http://www.cisco.com/warp/public/473/124.html
Let me know how it goes
12-16-2002 05:54 AM
Thank you, but I had already found that document.
What I need to know is if I can configure HSRP between 2 6000, where on has SUP1A PFC MSFC and the other SUP1A PFC MSFC/2?
Thanks
12-16-2002 05:56 AM
Yes..You sure can
12-16-2002 09:29 AM
I apologise for only getting back to you now, but I got busy with other stuff.
In the abovementioned document it mentions that, if MSFC's ROMmon is still not accessible then to power off and remove the MSFC. I´ve done that but still cannot access ROMmon. For the location of the MSFC, in the document "http://www.cisco.com/warp/public/473/124.html"
points to the back of the supervisor and the document "http://www.cisco.com/warp/customer/108/hwts_msfc_18000.html"
it points to the middle. What next?
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: