Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Cat6509+NAM+ATM --> TD will not discover atm ports...

Cat6509 has both ethernets and atm modules installed.

I can successfully monitor (via NAM/Traffic Director) all ethernet ports/vlans, but neither atm

ports nor virtual int of MSFC appear in the list of

ports discovered on the switch.

E.g., when roving for vlan 3 which has only ethernet

port members everything works great, but when roving

on vlan1 which has also atm-LANE trunk this atm port

does not appear in the Config manager port list, and no atm traffic can be viewed. However, the "show span" on the 6509 shows that atm ports *are* monitored to NAM in that case.

The TD config manager for the NAM agent insists the

network type is GigaEth, I cannot force it any other.

What am I missing?

Thanks in advance.

Alex

===========

1 REPLY

Re: Cat6509+NAM+ATM --> TD will not discover atm ports...

Since there has been no response to your post, it appears to be either too complex or too rare an issue for other forum members to assist you. If you don't get a suitable response to your post, you may wish to review our resources at the online Technical Assistance Center (http://www.cisco.com/tac) or speak with a TAC engineer. You can open a TAC case online at http://www.cisco.com/tac/caseopen

If anyone else in the forum has some advice, please reply to this thread.

Thank you for posting.

137
Views
0
Helpful
1
Replies
CreatePlease to create content