01-05-2004 03:02 PM - edited 03-02-2019 12:40 PM
I am converting a cat6513 to IOS. It's currently connected to 7 cat3500XL via gig ports. Gig ports are span between two blades on the 6513 created etherchannels to all cat3500xl (example: 6513 port 3/1 and 4/1 connected to cat3500-1 port 0/1 and 0/2). We are trunking vlans on these etherchannels. Because I have a short window for this project, I wanted to create the new config before blowing it up. Can someone please verify the below etherchannel and trunk config? Thanks in advance.
interface Port-channel1
description to IWD-01-A-3524-1B
no ip address
switchport
switchport mode access
spanning-tree portfast
switchport trunk encapsulation dot1q
switchport mode trunk
switchport trunk allowed vlan 1,3
interface GigabitEthernet3/1
description to IWD-01-A-3524-1B 0/1
no ip address
logging event link-status
logging event bundle-status
switchport
channel-group 1 mode on
interface GigabitEthernet4/1
description to IWD-01-A-3524-1B 0/2
no ip address
logging event link-status
logging event bundle-status
switchport
channel-group 1 mode on
01-05-2004 06:12 PM
If you are trunking, you will not need "switchport mode access" under the interface
You'll also need to configure trunking under the physical interfaces. Document for reference
01-05-2004 06:24 PM
Excellent white paper. Thank you very much.
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide