cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
169
Views
0
Helpful
1
Replies

Cat6K SUP1A with MSFC

znaqvi
Level 1
Level 1

I have SUP1A with Built in MSFC. I need to find out if I can turn off MSFC (layer 3) and just use this blade as a switch.

TIA,

1 Reply 1

Prashanth Krishnappa
Cisco Employee
Cisco Employee

Just do not configure anything on it and just use layer 2 Supervisor. If for whatever reason you do not want to see the MSFC, session into it, change the config-register to 0x0 and reload. It would boot into rommon and not show up in sh mod.

You can issue a 'switch console" from a console session and issue a manual boot if you need it at any time

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: