with supervisor engine 3, I am trying to reset the switch to facotry defaults. When I connect to the switch I get the switch booting up and all the modules in it ok'd but I can't type anything into the terminal. I've tried different machines as well as taking the flash card out but no luck. Please help would like to use the switch for a IP/Data Fiber back bone.
The need was to reach an host inside a LAN through a VPN connection managed by the LAN gateway (Cisco 1921).
The LAN gateway performs NAT and there was a dedicate nat rule for the host i wanted to reach through VPN.
I couldn't connect to the hos...
We have 3 identical switches configured by someone else and would like to claim some of the Gigabit ports(G1/G2/G3/G4) for use on servers. When we try to change the wiring and configuration, we run in to connectivity issues. Attached is a des...
This is actually a pretty cool feature, i didn't even know it existed until I was looking for a solution to advertise a subnet (prefix in BGP talk), only if a certain condition existed. This is exactly what conditional advertisements does