Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

Catalyst 1900 Network port

We inherited a Catalyst 1900 - I've managed to reset to factory defaults, and attempted to enable a network port (we'd like to use it in a similar fashion as a hub, as we've got a ton of these 1900's) - however, nothing I can do will get this to cascade to another switch, or even to a simple 3com hub. When plugged into a hub, switching the hub to "uplink" mode will light the LED on the network port - but in normal mode, the network port on the switch is dead - beyond simply designating the port as the network port, is there anything else that needs to be done here?

2 REPLIES
New Member

Re: Catalyst 1900 Network port

Are you using a CAT5 crossover cable?

New Member

Re: Catalyst 1900 Network port

No, I wasn't - I had assumed that wouldn't be necessary if the port was configured as a network uplink port - is that not the case? Thanks.

101
Views
0
Helpful
2
Replies