04-23-2002 06:38 AM - edited 03-01-2019 09:25 PM
We inherited a Catalyst 1900 - I've managed to reset to factory defaults, and attempted to enable a network port (we'd like to use it in a similar fashion as a hub, as we've got a ton of these 1900's) - however, nothing I can do will get this to cascade to another switch, or even to a simple 3com hub. When plugged into a hub, switching the hub to "uplink" mode will light the LED on the network port - but in normal mode, the network port on the switch is dead - beyond simply designating the port as the network port, is there anything else that needs to be done here?
04-23-2002 06:50 AM
Are you using a CAT5 crossover cable?
04-23-2002 07:21 AM
No, I wasn't - I had assumed that wouldn't be necessary if the port was configured as a network uplink port - is that not the case? Thanks.
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide