Well... depends on alot of things like Ethernet cabling type (Cat 3, Cat 5) and length, NIC type, segment loading, etc, but a FULL DUPLEX port on the 1900 has a theoretical throughput of 20 MB! A switch like the 1900 should get 80-90% of that, so you're looking at more like 16-18 MB . Even 10 MB half duplex should be about 8 to 9 MB.
Question We run asr9001 with XR 6.1.3, and we have a very long delay to
login w/ SSH 1 or 2 to the device compare to IOS device. After
investigation, the there is 1s delay between the client KEXDH_INIT and
the server (XR) KEXDH_REPLY. After debug ssh serv...
Introduction The purpose of this document is to demonstrate the Open
Shortest Path First (OSPF) behavior when the V-bit (Virtual-link bit) is
present in a non-backbone area. The V-bit is signaled in Type-1 LSA only
if the router is the endpoint of one or ...
Hi, I am seeing quite a few issues with patch install and wanted to
share my experience and workaround to this. Login to admin via CLI, then
access root with the “shell” command Issue “df –h” and you’ll probably
see the following directory full or nearly ...