Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Catalyst 2900XL, problem in password recovery

Dear professionals i tried the password recovery procedure for catalyst 2900xl, all the procedure completed successfuly. At the end I copied the config.text from flash to running-config in the system. This copy is also completed successfuly but after that i write any command on the prompt the message displayed is "command authorisation failed". please help me why this message is displayed and how to overcome this problem.

1 REPLY
New Member

Re: Catalyst 2900XL, problem in password recovery

Start all over again !!!

First set the console- and the telnet-password, then configure the 'enable secret'-password manually

Then copy your config into the switch without any passwords. So first remove the passwords which are in your old-config with some editor before copying it back to yourr switch.

Edwin van Wijk.

99
Views
0
Helpful
1
Replies
CreatePlease to create content