10-23-2002 11:20 AM - edited 03-02-2019 02:20 AM
We have a Catalyst 2948 with 6 VLANS configured. There is a statement in the config that states: set port speed 2/1-48 10. All of the ports I have used so far have been all 10 meg. Now I need to set port 18 to 100 meg. How do I do this and what commands are used so it doesn't affect the other 10 meg ports?
Thank you.
10-23-2002 11:23 AM
carol
set port speed 18 100
This will set the speed of port 18 to 100Mb
the config will be adjusted dynamically
You also need to reset the port to change the setting
10-23-2002 11:29 AM
What is the command to reset only port 18 or do I need to reset the switch?
Thanks again!
10-23-2002 11:40 AM
to disable
set port dis mod/port
set port en mod/port
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: