I have a CaAT 2950 and I want to configure port security on Fast Eth ports.
I´ve done the following config:
switchport mode access
no ip address
In the documentation in Cisco the say that - switchport port-security violation shutdons and switchport port-security maximum 1 - in the default config of the ports, but I gave that comands anyway. When I connect a PC to this port it appears is MAC but if I connect another PC the port doens´t shutdown.
port doesn´t shitdown when a new MAC connects to the port.
This document gives several answers on frequently asked questions for PFRv3 channel state behavior.
Q1: What are all the channel operational states from a BR (border role) perspective and what are the rules/conditions to be in each st...
The need was to reach an host inside a LAN through a VPN connection managed by the LAN gateway (Cisco 1921).
The LAN gateway performs NAT and there was a dedicate nat rule for the host i wanted to reach through VPN.
I couldn't connect to the hos...
We have 3 identical switches configured by someone else and would like to claim some of the Gigabit ports(G1/G2/G3/G4) for use on servers. When we try to change the wiring and configuration, we run in to connectivity issues. Attached is a des...