02-25-2004 01:38 PM - edited 03-02-2019 01:51 PM
Hi
I am trying to put a regular switching hub to one of the ports on a catalyst 2950. for some reason i cannot communicate between the catalyst and the third party switch. I checked the port security setting, its disabled. I could not figure out whats wrong. Need help
thank you
02-25-2004 02:17 PM
Hi,
first of all, is it a switch or a hub that you're trying to connect? Secondly, is the catalyst switch port lighting up? If not then check your cable. You'll probably need a crossover. If the port is lit up then check for speed/duplex mis-matches at each end of the link. Set both to the same speed and duplex (ie not auto) to play safe.
Good Luck
Teggs
02-25-2004 03:43 PM
thank you
it was speed setting that created the problem
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide