I am trying to put a regular switching hub to one of the ports on a catalyst 2950. for some reason i cannot communicate between the catalyst and the third party switch. I checked the port security setting, its disabled. I could not figure out whats wrong. Need help
first of all, is it a switch or a hub that you're trying to connect? Secondly, is the catalyst switch port lighting up? If not then check your cable. You'll probably need a crossover. If the port is lit up then check for speed/duplex mis-matches at each end of the link. Set both to the same speed and duplex (ie not auto) to play safe.
Question We run asr9001 with XR 6.1.3, and we have a very long delay to
login w/ SSH 1 or 2 to the device compare to IOS device. After
investigation, the there is 1s delay between the client KEXDH_INIT and
the server (XR) KEXDH_REPLY. After debug ssh serv...
Introduction The purpose of this document is to demonstrate the Open
Shortest Path First (OSPF) behavior when the V-bit (Virtual-link bit) is
present in a non-backbone area. The V-bit is signaled in Type-1 LSA only
if the router is the endpoint of one or ...
Hi, I am seeing quite a few issues with patch install and wanted to
share my experience and workaround to this. Login to admin via CLI, then
access root with the “shell” command Issue “df –h” and you’ll probably
see the following directory full or nearly ...