i m facing problem in particular one switch.In clustering environment of same series of switches (Catalyst 2950G-24-EI Switch ),if i put a particular one switch my network got jammed and all the switch LED blink very fastly & when i remove this particular switch everything is normal.
so plz help me , is this problem due to this particular switch and plz tell where is problem too.
this is because of purely broadcast which is being produced by a pc which ur trying to connect, to isolate that, connect the switch which u said ports are blinking fast & juz plug out 1 by 1 ports & plug in back if nothing changes has happened. when u plug out eg. say fast 0/12 & find that fast blinking stops, which means the pc which is connected on fas 0/12 is creating problem.
Question We run asr9001 with XR 6.1.3, and we have a very long delay to
login w/ SSH 1 or 2 to the device compare to IOS device. After
investigation, the there is 1s delay between the client KEXDH_INIT and
the server (XR) KEXDH_REPLY. After debug ssh serv...
Introduction The purpose of this document is to demonstrate the Open
Shortest Path First (OSPF) behavior when the V-bit (Virtual-link bit) is
present in a non-backbone area. The V-bit is signaled in Type-1 LSA only
if the router is the endpoint of one or ...
Hi, I am seeing quite a few issues with patch install and wanted to
share my experience and workaround to this. Login to admin via CLI, then
access root with the “shell” command Issue “df –h” and you’ll probably
see the following directory full or nearly ...