I have a 2955 switch that has been installed without completing the inital set-up. The switch is currently being used for a sensitive process that cannot be disrupted. My question is if I set the switch up via the console connection and assign an IP addy, will the switch re-boot when you save the settings to NVram? Can you access the switch via network assistant without saving the setting?
If it does than I need to wait for a shutdown window.
Configuration commands should not stop processing or reboot the switch. If you are only interested in doing simple things like names and IP address for management VLAN you should have nothing to worry about.
We are pleased to announce availability of Beta software for 16.6.3.
16.6.3 will be the second rebuild on the 16.6 release train targeted
towards Catalyst 9500/9400/9300/3850/3650 switching platforms. We are
looking for early feedback from customers befor...
Introduction Featured Speakers Luis Espejel is the Telecommunications
Manager of IENova, an Oil & Gas company. Currently he works with Cisco
IOS® and Cisco IOS XE platforms, and NX to some extent. He has also
worked as a Senior Engineer with the Routing P...
In this session you can learn more about Layer 3 multicast and the best
practices to identify possible threats and take security measures. It
provides an overview of basic multicast, the best security practices for
use of this technology, and recommendati...