I have a 3548 switch that I set to factory defaults and began to rebuild.
I think I have a few issues:
1. As it is coming up after a reboot I get the following message during RAM POST - "RAM failed sending read command"
2. The VTP settings I put in for client and domain are gone after reboot. It goes back to the blank value for domain and server. I have never had to do anything special to save these settings in the past.
Any help that can be provided on either of this issues would be greatly appreciated.
Question We run asr9001 with XR 6.1.3, and we have a very long delay to
login w/ SSH 1 or 2 to the device compare to IOS device. After
investigation, the there is 1s delay between the client KEXDH_INIT and
the server (XR) KEXDH_REPLY. After debug ssh serv...
Introduction The purpose of this document is to demonstrate the Open
Shortest Path First (OSPF) behavior when the V-bit (Virtual-link bit) is
present in a non-backbone area. The V-bit is signaled in Type-1 LSA only
if the router is the endpoint of one or ...
Hi, I am seeing quite a few issues with patch install and wanted to
share my experience and workaround to this. Login to admin via CLI, then
access root with the “shell” command Issue “df –h” and you’ll probably
see the following directory full or nearly ...