09-12-2006 05:47 AM - edited 03-03-2019 04:59 AM
I am replacing a 2950 and a 2600 with a 3750 Switch. where do I put the routing information? ex. RIP, EIGRP ect...
Thanks
DMan
09-12-2006 06:03 AM
Darnell,
The switch will come with an IOS similar to a router. The syntax will be the same, just make sure you enable routing by typing
ip routing
while in config mode.
09-13-2006 04:05 AM
Thanks!
09-12-2006 09:02 AM
Please refer the below URL for configuring RIP,OSPF,EIGRP,etc on the Catalyst 3750 Switches.
http://www.cisco.com/univercd/cc/td/doc/product/lan/cat3750/12225see/scg/swiprout.htm#wp1372733
I hope it helps.
Regards,
Arul
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community:
