Catalyst 4003 can't be autoboot~

[wellsgz]

The catalyst 4003 switch can't be autoboot after power cycle~

But i can be autoboot after hot reset by command "reset"~

anybody meet the same question before?~

thanks a lot~

ZiXi Wei

[milan.kulik]

What is the sh boot output?

Read http://www.cisco.com/univercd/cc/td/doc/product/lan/cat5000/rel_5_5/sw_cfg/boot.pdf for details.

Regards,

Milan

[cminch]

What SUP are you using? I have had a few even thought the config bits were set, the bootvar, and system flash was all coreect if the power went out (i.e. truned off) it always went into Rommon. This has happened about 4 times, and I am seing more of it. Each time we had to RMA the SUP. Just make sure your config-reg is set properly and everything else is ok, you could have the same problem.

Regards,

Corey

[wellsgz]

We using sup1, and seems after i upgrade the ROMMON version from 4.x to 6.1 the problem solved~

i think there is some bug at the former ROMMON version~