09-16-2003 05:01 PM - edited 03-02-2019 10:23 AM
The catalyst 4003 switch can't be autoboot after power cycle~
But i can be autoboot after hot reset by command "reset"~
anybody meet the same question before?~
thanks a lot~
ZiXi Wei
09-16-2003 10:53 PM
What is the sh boot output?
Read http://www.cisco.com/univercd/cc/td/doc/product/lan/cat5000/rel_5_5/sw_cfg/boot.pdf for details.
Regards,
Milan
09-17-2003 03:43 AM
What SUP are you using? I have had a few even thought the config bits were set, the bootvar, and system flash was all coreect if the power went out (i.e. truned off) it always went into Rommon. This has happened about 4 times, and I am seing more of it. Each time we had to RMA the SUP. Just make sure your config-reg is set properly and everything else is ok, you could have the same problem.
Regards,
Corey
09-23-2003 08:32 PM
We using sup1, and seems after i upgrade the ROMMON version from 4.x to 6.1 the problem solved~
i think there is some bug at the former ROMMON version~
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: