Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
Community Member

Catalyst 4003 error in "session 2" command

I want to configure L3 module of Catalyst 4003. When I command "session 2" at the L2 modlule of Catalyst 4003, error message "SYS-3-MOD-ILCGSGNOREPLY" was appeared. What's wrong and how can I fix this problem ?

3 REPLIES
Cisco Employee

Re: Catalyst 4003 error in "session 2" command

Can you console into the L3 blade? What software version are you running on the Supervisor. There is a related bug which is fixed in latest 5.5(x) and 6.4(x)

Community Member

Re: Catalyst 4003 error in "session 2" command

Thanks a million!

The version of WS-X4013 : Hw:3.2, Gsp 6.1(1.0), Nmp 6.1(1)

WS-X4232-L3 Hw 1.7

The version of L3 : 12.0(7)W5(15b)

The ping command to sc0 from L3 cann't reach.

Please give some idea for this problem.

Silver

Re: Catalyst 4003 error in "session 2" command

This is the meaning of such error message:

%SYS-3-MOD_ILCGSGNOREPLY: Exceeded max # of retries sending 0x[hex] msg to ILC module [dec]

This message indicates that the SCP message exchange between the NMP and the module exceeded the maximum number of retries. 0x[hex] is the opcode in hexadecimal and [dec] is the module number.

Recommended Action: Verify that the module is online. If the problem persists, contact your technical support representative.

HTH

158
Views
0
Helpful
3
Replies
CreatePlease to create content