I recently upgraded code on a Cat 4006 with a SUP IV engine to Version 12.2(25)SG from Version 122-18.EW. The switch seems to be running at a higher CPU since the upgrade and doesn't handle broadcast traffic as well. This switch is my ROOT. It has reloaded twice due to braodcast traffic. I know I can probably prune my trunks better to eliminate the broadcast proliferation, however I did not have the problem before the code upgrade.
Question We run asr9001 with XR 6.1.3, and we have a very long delay to
login w/ SSH 1 or 2 to the device compare to IOS device. After
investigation, the there is 1s delay between the client KEXDH_INIT and
the server (XR) KEXDH_REPLY. After debug ssh serv...
Introduction The purpose of this document is to demonstrate the Open
Shortest Path First (OSPF) behavior when the V-bit (Virtual-link bit) is
present in a non-backbone area. The V-bit is signaled in Type-1 LSA only
if the router is the endpoint of one or ...
Hi, I am seeing quite a few issues with patch install and wanted to
share my experience and workaround to this. Login to admin via CLI, then
access root with the “shell” command Issue “df –h” and you’ll probably
see the following directory full or nearly ...