Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

Catalyst 4006 rebooting without explanation

I'm having some problems with my Cisco Catalyst 4006. I changed the CatOS from Version 6.3(10) to Version 7.6(2) because I bought a module WS-X4448-GB-RJ45. After that my Switch is booting without any explanation.

Does anyone have any idea what can be happening ?

3 REPLIES
VIP Purple

Re: Catalyst 4006 rebooting without explanation

Hello,

can you put the output of the ´show stacks´ command after a reboot has happened ?

Regards,

Georg

New Member

Re: Catalyst 4006 rebooting without explanation

If it is actually crashing, check the stack. It's possible that it may be corrupted if it has never been cleared. So, capture the stack, clear it, wait for another crash, capture it again, and open a case with TAC to analyze root cause.

show crashdump 1

clear crashdump 1

New Member

Re: Catalyst 4006 rebooting without explanation

Hi robho,

I got the "crashdump" and put it on the output interpreter analyzer. The result was:

CATALYST STACK DECODE NOTIFICATIONS (if any)

Error : Could not decode symbols

The crashdump has been cleared and I'm monitoring the switch.

best regards

thank you,

ACL

123
Views
0
Helpful
3
Replies