Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
Community Member

Catalyst 4006 with Sup III

How would I clear the counters of an interface like fast ethernet. could this be done globally on all interfaces or a particular module and interface? This would be of particular interest to check incrementing errors like CRC/FCS and alignment errors. Thanks.

3 REPLIES
Community Member

Re: Catalyst 4006 with Sup III

I believe you just need to type the following command at the priv exec prompt:

clear counters %interface type% %mod/port%

example:

Switch#: clear counters fa 0/1

This should reset the counters on the interface. Hope this helps.

Josh

Community Member

Re: Catalyst 4006 with Sup III

Josh,

Thanks again for the command. It's amazaing the response is so quick and effective.

Community Member

Re: Catalyst 4006 with Sup III

Well I found the answer myself clear counters. But I try first Network Professional Connection and I do appreciate the excellent feedback. Thanks.

92
Views
0
Helpful
3
Replies
CreatePlease to create content