Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements
Webcast-Catalyst9k
New Member

Catalyst 4500 series Line card 4524G-24 POE

Hi Pros,

Please help me to solve the below issue

- The POE line card module 4524 in the 4510R switch is not suppling the power to the Cisco phone (cp-7912G) and AIR-1230B wlan access point.

I already tried #hw-module power to enable the module and slot and #power inline auto to the specific interface.But still the module POE LED is off.

Could you give me the steps to bring the module POE enable. Now for timebeing using 3550 POE switch.

Thanks

swamy

3 REPLIES
Silver

Re: Catalyst 4500 series Line card 4524G-24 POE

Hi Swamy

Are you saying POE module is off?

Perhaps first you should check if your IOS version supports this module. Can you post the output from "sh ver" and "sh mod" ?

New Member

Re: Catalyst 4500 series Line card 4524G-24 POE

Dear Jolmo,

Please see the attachemnt for both sh ver and sh module details

swamy

New Member

Re: Catalyst 4500 series Line card 4524G-24 POE

Dear Jolmo,

I had gone thro the datasheet for 4500 series power supply and found that the 1400Watts AC is for data only not included POE. 1300, 2800 supports both Data and POE.

I hope that due to this

The following message

RUWCore1#sh power

Power Fan Inline

Supply Model No Type Status Sensor Status

------ ---------------- --------- ----------- ------- -------

PS1 PWR-C45-1400AC AC 1400W good good n.a.

PS2 PWR-C45-1400AC AC 1400W good good n.a.

Power supplies needed by system : 2

Power supplies currently available : 2

Power Summary Maximum

(in Watts) Used Available

---------------------- ---- ---------

System Power (12V) 575 2473

Inline Power (-50V) 0 0

Backplane Power (3.3V) 40 40

---------------------- ---- ---------

Total 615 2513

Here the in line status n.a is due to the unsuppoted power model 1400AC

Thanks

swamy

266
Views
0
Helpful
3
Replies
CreatePlease to create content