04-25-2006 02:32 AM - edited 03-03-2019 02:56 AM
hi everybody
could you pls tell me that is there any ios that support nat in 4500 switches?
04-25-2006 02:38 AM
Hi Ladan,
Its not supported on cat4500 series.
Have a look at this link
http://www.cisco.com/warp/public/473/166.html#topic1
Only exception is Catalyst 4500/4000 series switches with Supervisor Engine III/IV support the Access Gateway Module (AGM) in Cisco IOS Software Release 12.1(13)EW or later. You need Cisco IOS Software Release 12.2.13T or later on the AGM module. NAT has support in the software switching path on the AGM module.
HTH, if yes please rate the post.
Ankur
04-25-2006 03:19 AM
Hi ankurbhasin
thanks for your help. someone told me that ios software release 12.4 support NAT on 4500. could you tell me about this subject?
thanks
04-25-2006 03:22 AM
Hi Ladan,
AFAIK there is no such release for cat4500 switch and the latest release for 4500 switches is Cisco IOS Software Release 12.2(31)SG
Check this link
http://www.cisco.com/univercd/cc/td/doc/product/lan/cat4000/index.htm
HTH, if yes please rate all post.
Ankur
04-25-2006 02:39 AM
Hi,
NAT is not supported on the 4500 series, in any IOS version.
Hope that helps - pls do remember to rate posts that help.
Paresh
04-25-2006 03:21 AM
Hi Ladan,
The Cat4500s do not have any 12.4 software at all. The latest you can get is 12.2...
Paresh
04-25-2006 03:26 AM
thanks too much
I found it.
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: