02-26-2006 03:57 PM - edited 03-03-2019 02:01 AM
I have a Catalyst 4503 switch. When I reset the switch it boots to new configuartion wizard.
I am writing the configuration to NVRAM using the wr mem command. I believe it may be to do with the config register:
Cat4503#sh bootvar
BOOT variable does not exist
CONFIG_FILE variable does not exist
BOOTLDR variable does not exist
Configuration register is 0x8101
Solved! Go to Solution.
02-26-2006 04:31 PM
You are right change it to 0x2101 or 0x2102 and you should be fine . 0x2102 will require a boot statement to boot correctly where 0x2101 will just find the first image in bootflash and load that .
02-26-2006 04:31 PM
You are right change it to 0x2101 or 0x2102 and you should be fine . 0x2102 will require a boot statement to boot correctly where 0x2101 will just find the first image in bootflash and load that .
02-26-2006 11:33 PM
Thanks.
Yep just did a restart and all good.
Cheers.
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: