Catalyst 5xxx supervisor engine II filesystem (ws-x5509)
Could somebody explain me how is the filesystem for Catalyst 5xxx organized and what commands should I use for navigating?
There is a big difference in CLI between sup engine II and sup engine III. And I can not use commands like "dir" for sup II. How can I see the exact name of ios image in flash for sup II for example in order to upload it to tftp server?
Why are there so many files in ouput of command show flash:
Re: Catalyst 5xxx supervisor engine II filesystem (ws-x5509)
On the Supervisor Engine II G and III G, a limited Flash file system is implemented in software release 5.2 and later. Up to two configuration files, cfg1 and cfg2, can be stored in Flash memory. Each configuration file can be up to 256 KB. When you give show flash , it lists the configuration files stored in Flash. The following document is the best for you.
This is actually a pretty cool feature, i didn't even know it existed until I was looking for a solution to advertise a subnet (prefix in BGP talk), only if a certain condition existed. This is exactly what conditional advertisements does
j ai une question j ai achete un routeur cisco 887VA-k9 , je le configuré avec la configuration ci- dessous
si je le lier avec mon pc portable sur l un de ses ports directement ça marche toute est bien ( la connexion internet + m...
Attached policy provides CLI access to the Cisco 4G router over text messaging. Two files are in the attached .tar file:
2. PDF with instructions on how to load and use the .tcl file.