Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements
Webcast-Catalyst9k
New Member

Catalyst 6000 - switching mode

Hi,

I woud like to setup switching mode on Catalyst 6000 with CATOS. The default switching mode is "store and forward" and I want to change to "cut through" or "fragment free".

1 REPLY
New Member

Re: Catalyst 6000 - switching mode

This is not possible - most Catalyst-series switches are "store and forward" - with specialised line-card ASICs for frame-forwarding and FCS-checking used in these switches, there is no real advantage in using cut through switching.

98
Views
0
Helpful
1
Replies
CreatePlease to create content