I have had multiple module failures of my 6348 mods across the campus that apparently have a bad chipset lot. Does DFM 1.1 have a specific instance or event that will notify me if traffic stops, even when all ports show connected via the console?
NOt possible. these failures are not monitored and there are no specific event that corresponds to such failures. And when the traffic stops, DFM assumes that the it is within the threshold limit set and does not generate an alarm,
If there are any syslog messages generated co-relating to the component failures, then RME -> Syslog analyser will be a good place to check.
Hi everyone, I would like to thank you in advance for any help you can provide a newcomer like myself!
Im studying the 100-105 book by Odom and am currently on the topic of Port security. I purchased a used 2960 and I'm trying to follow a...
While deploying a number of 18xx/2802/3802 model access points (APs), which run AP-COS as their operating platform. It can be observed on some occasions that while many of their access points were able to join the fabric WLC withou...
I am going to design and build an LAN network under a tunnel underground with long distance between the switches.
I will have 2 Catalyst switches and 8 Industrial IE3000, and they will be connected with fiber.
For now I am planning on use Layer-2 s...