Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements
Webcast-Catalyst9k
New Member

Catalyst 6500 question

I'm working on a catalyst 6500 and trying to set up the VLANs on it. I session into MSFC and go to "Router (config)#". However from there "ip routing" command is not available to enable the routing. Any idea?

Thanx

3 REPLIES
Cisco Employee

Re: Catalyst 6500 question

I tried it in the lab switch and I do see the command. Is your MSFC in boot mode? Can you paste output of show version

Router(config)#ip ro?

route routing

Router(config)#ip routin

Router(config)#ip routing

Router(config)#

New Member

Re: Catalyst 6500 question

Yes. It is in the boot mode. How do I get out of it?

Thanx.

Cisco Employee

Re: Catalyst 6500 question

do a "dir bootflash:" and see if you have a valid IOS file. If you do, set a boot variable using the following commands

conf terminal

boot system flash bootflash:

config-register 0x2102

end

wr mem

reload

99
Views
0
Helpful
3
Replies
CreatePlease to create content