Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
New Member

Catalyst 6500 Supervisor engine issues....

I am getting the following errors when a reset our catalyst 6500:

SCP Communication error with Module 2

2003 May 23 21:16:53 %QOS-3-SETDEFCOSFAIL:Unable to set default CoS on port 2/1. Error code -255

2003 May 23 21:16:53 %QOS-3-SETDEFCOSFAIL:Unable to set default CoS on port 2/1. Error code -255

2003 May 23 21:17:02 %QOS-3-SETTRUSTFAIL:Unable to set trust type on 2/1. Error code -255

2003 May 23 21:17:02 %QOS-3-SETTRUSTFAIL:Unable to set trust type on 2/1. Error code -255

2003 May 23 21:17:11 %QOS-3-SETDEFCOSFAIL:Unable to set default CoS on port 2/2. Error code -255

2003 May 23 21:17:11 %QOS-3-SETDEFCOSFAIL:Unable to set default CoS on port 2/2. Error code -255

2003 May 23 21:17:20 %QOS-3-SETTRUSTFAIL:Unable to set trust type on 2/2. Error code -255

2003 May 23 21:17:20 %QOS-3-SETTRUSTFAIL:Unable to set trust type on 2/2. Error code -255

Failed Module Bringup Process

Please Help..

2 REPLIES
Gold

Re: Catalyst 6500 Supervisor engine issues....

This message indicates that the desired trust type could not be set on the module. [dec]/[dec] is the module number/port number.

Recommended Action: Check the module for hardware problems. If a problem is not obvious, contact your technical support representative.

pretty much sums it up

Cisco Employee

Re: Catalyst 6500 Supervisor engine issues....

What module do you have in slot 2? Do you see this only when the module in slot 2 is reset and when it comes online? If so, then there is a minor bug

"Error code -255 when update EPLD on module while it in reset process"

255
Views
0
Helpful
2
Replies
CreatePlease to create content