Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Catalyst 6509 Console Dial-in

I was trying to access Catalyst 6509 Console Dial-in Access.

I connected a us robotics modem to console of switch.

iam not getting dial auto answer from modem.

but if i remove console cable from modem.

and after modem neogociation is finished i connect console cable.

then i can access switch.

Why is this behaviour.

and if you could tell me the right procedure to access catalyst 6509 remotely from dial-in.

Regards,

2 REPLIES
Cisco Employee

Re: Catalyst 6509 Console Dial-in

Take a look at the modem settings on the following page

http://www.cisco.com/warp/public/473/2.html

New Member

Re: Catalyst 6509 Console Dial-in

I have done all possible setting's from the above link.

even TAC engineer suggested me this link.

As i said it works fine but what i have to do is remove console cable from modem and let modem negociation finish and then connect console cable to access the switch.

102
Views
0
Helpful
2
Replies
CreatePlease login to create content