Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

Catalyst 6509 switch GE and FE Modules

Hi All,

On a CAT-6509, when I remove the GE or FE modules from the chassis ,will that configuration on the GE/FE modules disappear and when I insert it back will that configuration is going to reappear ?

Regards,

Madan

1 REPLY

Re: Catalyst 6509 switch GE and FE Modules

On a Native Mode yes, the configuration for that line card will remain in the running-configuration and therfore the same config will retunr upon insertion of that same line card, it's called "slot provisionining".

Bug id CSCsb49891 is an enhancement to the IOS that clears the configuration of the removed line card or turns off the "slot provisioning".

router(config)#module ?

ContentServicesGateway Configure a CSG module

ContentSwitchingModule configure a CSM SLB module

clear-config To clear configuration when module is removed

provision Configure module provision status

router(config)#module clear-config

The above CLI knob is present in 12.2(18)SXF or above so in your case, you will not have the knob, you need to reload the switch to remove the removed line card's configuration.

Please rate all posts.

162
Views
0
Helpful
1
Replies