Catalyst Express 500 24TT linked to an unmanaged switch
I'm trying to hang an unmanaged switch (netgear FS108)off this switch but with little success. I've configured the port on the Express 500 as a switch port but nodes connecting through the unmanaged switch can't fully browse nor can they receive DHCP addresses. Is there someway to make this work or are these Netgear switches simply not supported and won't work period?
Re: Catalyst Express 500 24TT linked to an unmanaged switch
Yup, that worked. I assume the same issue applies to the 'server' port setting. If I've created multiple virtual servers each with their own unique IP address, the 'server' port settings spits back an error not allowing multiple connections through the same port.
Hi everyone, I would like to thank you in advance for any help you can provide a newcomer like myself!
Im studying the 100-105 book by Odom and am currently on the topic of Port security. I purchased a used 2960 and I'm trying to follow a...
While deploying a number of 18xx/2802/3802 model access points (APs), which run AP-COS as their operating platform. It can be observed on some occasions that while many of their access points were able to join the fabric WLC withou...
I am going to design and build an LAN network under a tunnel underground with long distance between the switches.
I will have 2 Catalyst switches and 8 Industrial IE3000, and they will be connected with fiber.
For now I am planning on use Layer-2 s...