Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Catalyst Uplink cable type

Hi We have a Cisco 3750 catalyst switch acting as L3 core with GLC-T= 1000BASE-T SFP modules.We have 3560 access switches with GLC-T= 1000BASE-T SFP modules.

What kind of Cat 5(or 6)cables we need to use to connect the access switch to the core using GLC-T= modules??

Usually we use cross cables to connect between switches.

Will straight cables also work???

Regds

Murali

2 REPLIES

Re: Catalyst Uplink cable type

Hi

you can make use of Category 5, 5e, or 6 unshielded twisted pair (UTP) cable for the same with RJ-45 type connector for connecting the same..

regds

VIP Purple

Re: Catalyst Uplink cable type

Hello,

in addition to the other post, check if your ports support the ´mdix auto´ command, which enables the ports to automatically detect a straight or crossover cable, hence making it insignificant which one you use.

Check this info from CCO:

You can use the mdix auto interface configuration command in the CLI to enable the automatic medium-dependent interface crossover (Auto-MDIX) feature. When the Auto-MDIX feature is enabled, the switch detects the required cable type for copper Ethernet connections and configures the interfaces accordingly. Therefore, you can use either a crossover or a straight-through cable for connections to a copper 10/100, 10/100/1000, or 1000BASE-T SFP module port on the switch, regardless of the type of device on the other end of the connection.

The Auto-MDIX feature is enabled by default on switches running Cisco IOS Release 12.2(18)SE or later. For releases between Cisco IOS Release 12.1(14)EA1 and 12.2(18)SE, the Auto-MDIX feature is disabled by default. For configuration information for this feature, see the switch software configuration guide or the switch command reference.

HTH,

GP

569
Views
0
Helpful
2
Replies
CreatePlease login to create content