I am currently attempting to configure 2 VLANs on my ASA5520 and allow them to communication with my Catalyst 500 switch. The ASA Setup is fairly simple (to start) its 2 Sub-ints on the g0/0 interface. The Switch IP is 66.38.173.xxx 255.255.255.224
Int g0/0.1 vlan 10 Nameif outside66 ip: 66.38.173.xxx 255.255.255.224
Int g0/0.2 vlan 20 Nameif outside64 ip: 64.187.16.xxx 255.255.255.224
G0/0 Port on the ASA is connected to port 2 on my Catalyst. I set the Smartport on port 2 of the Catalyst to be Router for trunking purposes (I also tried Switch during testing). For some reason I cant ping from the ASA to the switch? I have also set up an access list to Allow ICMP Any any on the ASA.
I get a notification error on the Catalyst saying "Undersized frames detected from the connected device" (which is my ASA). This notification comes up each time I try to ping from the ASA to the Catalyst... does anyone have a suggestion? Or a link to sample config.
Hi everyone, I would like to thank you in advance for any help you can provide a newcomer like myself!
Im studying the 100-105 book by Odom and am currently on the topic of Port security. I purchased a used 2960 and I'm trying to follow a...
While deploying a number of 18xx/2802/3802 model access points (APs), which run AP-COS as their operating platform. It can be observed on some occasions that while many of their access points were able to join the fabric WLC withou...
I am going to design and build an LAN network under a tunnel underground with long distance between the switches.
I will have 2 Catalyst switches and 8 Industrial IE3000, and they will be connected with fiber.
For now I am planning on use Layer-2 s...